The ADXL345 is a MEMS accelerometer made by Analog Devices. It’s a popular device among hobbyists because of its low cost, easy availability and rich feature set. But apparently you should be careful about where you buy them: one of my readers ended up with a bunch of ADXL345s that had significant offsets, measurement axes that didn’t work at all, and an inoperative freefall detection mode. After spending lots of time trying to get them to work, he decided to send them to me instead and hopefully find out what was wrong with them.
I recently read a forum thread where someone showed how a set of LME49710s that he bought online didn’t function the way they should. Although the chips apparently contained an op amp, they were unable to amplify a 60 kHz square wave and output a triangle wave instead. This means that the op amps’ slew rate is too low: the LME49710 is specified to reach 20 V/us, but these chips only managed 0.5 V/us or so.
The thread’s author asked if anyone could help identify his chips, and I offered to examine them for him. A few days later I received the op amps in the post. They were clearly marked with the National Semiconductor logo and “49710” as a model number:
I recently read a discussion on an electronics forum where someone had trouble getting an IR2104 to work correctly. He had bought these from a shady online store and could not get the correct signals to come out. I offered to analyze the chips, and one of the contributors to that discussion very kindly sent me a couple of them.
The IR2104 is a half-bridge MOSFET driver, which is used to drive the FETs in circuits like DC-DC converters and class-D power amplifiers. It’s made in a high-voltage CMOS process and is capable of driving the high-side FET at voltages up to 600V. The original designer and manufacturer is International Rectifier (IR), one of the first manufacturers of diodes, transistors and power management ICs. Currently the IR2104 is manufactured by Infineon, after it acquired IR in 2015.
The good old 741 op amp is way more versatile than I first thought. After dissecting two sets of varying designs (here and here) I managed to get my hands on even more different varieties, from all over the world, from the 1970s to the 21st century.
The DS18B20 is a digital temperature sensor that communicates through the One-Wire protocol. Like the DS2401 that we looked at earlier, it is housed in a three-pin TO92 package and can be read out using just one pin (plus ground). It’s made and sold by Maxim Integrated, although still labelled “DALLAS” on the package. Introduced in 1999, the DS18B20 was the successor to the DS1820 and provided a higher resolution (up to twelve bits, instead of the DS1820’s nine).
This part has become wildly popular over the past few years, because it is reasonably cheap, quite accurate, and very easy to use with microcontrollers. It is widely available online, but its popularity has, unfortunately, also given rise to an industry of fake DS18B20s. Although they usually work, there is no guarantee that they meet the specs listed in Maxim’s datasheet.
These fake chips are made by small semiconductor companies that have designed a drop-in replacement for the Maxim part, copying the exact functionality. There’s nothing wrong with second-sourcing a part like that (it’s how many semiconductor companies started in the first place), but marking them with the Dallas brand and selling them as if they’re genuine Maxim parts is of course illegal. Most likely it’s not the manufacturers that apply the fake label, but shady companies that buy large stacks of second-source chips, re-label them and sell them as if they’re the real thing.
